After doing some research and Investigation; this has become overwhelming, very exciting and an ambitious project for me. At this time I am going nowhere and hence I decided to have a phased approach to set my expectation for better success rate. Please provide your valuable guidance/input if I missed anything here and/or if I am expecting too much out of this project (FYI – I drive 95 Honda Accord). -Thanks; Tushar
Phase I (Pilot or POC - Proof of Concept Phase ):
a. Use kitchen container to build basic cell (Config: 1/8 gap, -nnnn+nnnn-
Using SS Wall Plates)
b. Measure & Test Output (expected 1 liter per minute gas output)
Phase II:
a. Build appropriate cell Housing (4” PVC Pipe; 8/10 or 12” long);
b. Upgrade SS Plate to 316; 20 Gauge (11 Plate Config)
c. Build Bubbler
d. Connect hoses and Pipe fittings
e. Measure & Test Output (expected 1 liter per minute gas output)
Phase III:
a. Install in Car w/o wiring and pipe fittings (Drive car around to make sure nothing falls apart)
b. Connect wires and hoses
c. Test drive
d. Measure success (MPG improvements)
Phase IV (based on Phase III Success):
a. Add Power with Modulation (PWM)
b. Add EFE – and O2 Sensor Modification
c. Add Air/Fuel Mixture circuit
d. Pressure Switch to disconnect Power supply to stop building excessive pressure
Phase V (Automation):
a. Add Temp Control and Water Cooling / Radiator
b. Add Water level/Float Switch to supply Electrolyte from Reserve tank