So it started tonight ...
I ran to walmart, got 3 containers, 4.9L, 2.8L and 1.5L.
The large one is the electrolyte solution container, the 2nd largest is the fluid measurement transfer container where the water originates, the 3rd largest is the fluid measurement transfer container where the water will end up, so I can see how long it takes the HHO to displace a liter of water.
Here are some videos of my first few experiments, I have 4 plates that are 2.5 x 5", with a 1.6mm nylon washer acting as a spacer in between each plate. It gets 13.8 to 14 volts via 10gauge wiring, 2 aligator clamps and a battery charger. I may get a battery at some point, but I don't have an extra at the moment.
This video is just with straight stream water (which I figure is the same as rain water) and nothing added to it
http://www.zippyvideos.com/2722386727642166/mov00328/
This video is with 1 gallon of stream water, mixed with 1/8 of a cup of table salt
http://www.zippyvideos.com/1988427027642156/mov00329/
And finally, here is the HHO bubbling out, I believe that my container had some leaks, so I may be able to get it to bubble even better, but how does this look for production, anyone?
http://www.zippyvideos.com/5270880677642186/mov00330/
Once I get the other containers/hoses to seal properly, I'll then time how long it takes to displace a liter of water from the 2nd largest container to the 3rd largest container.