I hope so Roland...
Has any scientific reseach been conducted? Research where accurate results have been published? We all have done our own research and tested different theories but we all seem to come up with different results. Is this because we are looking at the issue from different angles?
I'd say yes, enough reseach has been done, but im not sure where to stear you find it in one spot. the MMW numbers says it all.
I'm currently developing a wrapped cell (two plates wrapped around each other) purely because there is the most surface area given the smallest volume. I know this comes at an increased cost to produce but i haven't seen much information pertaining this arrangement and wish to test it out myself. The wrapped cells also have the least amount of edges givin the greatest surface area.
If the highest losses occur at the edges of the plate would it be desirable to roll the edges over so the sharp edges are not just pointing into the ether and creating 'white noise' within the cell? Or is this power loss just being converted to heat? What happens to it?
I don't know, good question
And what would be the best way to test for efficiency? output/current (lpm/A) or ???
MMW rating
. Mililiter / Miniute / Watt. How many Mililiters can be produced in 1 Minute with each Watt of power.
So many questions....lol
I'm going to hit the books again and try to work this out. I checked out the link
http://www.thefreedictionary.com/emf but didn't find it that helpful. Thanks anyway
Oh what do you mean by 'sealed cells' Roland?
Sealed cell - Dry cell - Tero type cell.
Any thoughts on any of this??????