hello, im planning my set up using 2 HHO cells, would i need 2 PWM or one?
thanks!
hello, im planning my set up using 2 HHO cells, would i need 2 PWM or one?
thanks!
IMO you would need two, one for each cell. The reason for this is no two cell are alike and each one will have it's own resonate frequency.
Depends. Are you going to finely tune the PWM's each time you start your car? If not, then it doesn't matter, because you won't be anyplace close to the frequency required for super high production anyways.
What's the current limit of your PWM? Make sure your cell's don't draw more current together then it's limit. Just wire them in parallel.
Well likely more along the lines of 12-14a. There will be greater resistance than would be otherwise evident by running them in parallel. The more I think about it, you may have been right to get two just from a current standpoint. My initial answer may have been a bit short sighted. I just don't agree with getting 2 from a resonance standpoint.
would a 60 amp pwm work for 2 cells?