Printable View
Please use this thread to describe your testings.
Only automotive applications please=car battery like power source.
amp meter ,volt meter,hho l/m mesuring device,
Describe:
-amps
-voltage
-liter/minute
-temperature
Then clearly describe design:
-steel used
-plates design :dimensions ,spacing
-enclosure design
-solution
-other
Cost$+-
-12amps
-13.5 v
-0.5l/m
-very light temperature after 15 min run time
-EN 1.4460 SS (magnetic 3x8 spatula www.waresdirect.com)
- 9 plate 3x8x1mm(about 21ga submerged leaving about 1/2"above water) +nnn-nnn+ 4x5/8" aligned holes in each neutral,1.5mm spacing(little larger that plate thickness it self)
- active area 202.5 sq.inch
-pvc 3" pluming (home depot)
-pinch of KOH flakes/distilated water (ebay from snackking)
-vertically placed plates,sides sealed with plastic from water jug melted on to the side "ribs" of the cell by heating the plates and resting it on strip of plastic from distillate water jug.
-50$
This is a great thread. It's just the info. I was looking for.
My interests are in the following parameters.
1. LPMs,
2. Power(Volts and Amps),
3. Active Surface Area of the electrodes(i.e. if 2 square plates are used and they measure 1" by 1"(thickness does not count) and they are fully submerged then that is 2 square inches of active surface area.
4. Plate spacing,
5. Chemical used,
6. Electrolyte temperature(after settling).
PLEASE, if anyone looking into this thread has a variable power supply hooked up to their electrolyzer, please step the voltage a few times, measure the LPMs and report your findings.