HydroJ
11-12-2012, 08:34 AM
I have built my first hho generator, I decided to build a simple wet cell for my first try. So I used 12 304SS plates that are 12"L x 4"W. I know 304 isn't the best for hho making but I wanted to keep the cost low for my first one to make sure it was going to work. I am running the 12 plates like
+ n n n n n n n n n n - I am running them on rectified 120v and is producing a pretty good bit of hho. I built an acrylic container to house the plates and made a lid with a seal, so that it is air tight. My problem is that when I stick my outlet tube in a container with water in it no gas bubbles out unless I have the tube going sideways on top of the water with the tube barely submerged it will bubble some. But if I turn the tube towards the bottom of the container, no gas will bubble out. I have sprayed soapy water on my lid seal and connections where they come through the lid, but I am not seeing any bubbles as if it were leaking. What could be the problem?
+ n n n n n n n n n n - I am running them on rectified 120v and is producing a pretty good bit of hho. I built an acrylic container to house the plates and made a lid with a seal, so that it is air tight. My problem is that when I stick my outlet tube in a container with water in it no gas bubbles out unless I have the tube going sideways on top of the water with the tube barely submerged it will bubble some. But if I turn the tube towards the bottom of the container, no gas will bubble out. I have sprayed soapy water on my lid seal and connections where they come through the lid, but I am not seeing any bubbles as if it were leaking. What could be the problem?