Turbo ? along with gasket thickness ?

[MasterCATZ]

I am planing on building remote Turbo for car with Hydrogen input I was planing on just letting the Turbo just suck up the Hydrogen being Fed to it passively

Questions

#1) Will hydrogen ignite inside the Turbo ? PSI up to around 15

I never thought about this until someone here mentioned the heat
remote Turbo's have no inter-coolers either ( rear of car kept in the breeze)

I did not want to have to pump the Hydrogen into the manifold due to competing with Turbo PSI

also I do not want to inject it into the Cylinder Directly

#2) how much spacing is required between plates

#3) has any one used liquid gaskets before
( we use them for our Drag Race engines )

#4) Dry plate Cell or Dry Tube cell , which is the most efficient?

I am planning on mounting Dry cell in the Front Bumper around 8 x 20x 4 inch space not being used where the hoods lock is

or mounting in the rear tail light area having 2x generators each side



Pre turbo testing maybe just under the battery where 12x12 area is which would allow be to have the bubblier directly above it , but would quickly fill up the limited engine bay space the Nissan NX has with is SR20DE FWD