cad help plz

[byrd9790]

I was woundering if any one has a way to put my design into a cad program, my local metal shop want big money to do that for me. 8"*8" 15 or 16 plate dry cell (if i use one reactor or 2 in 1),(and pending out put of my alt) stagered holes in bottom corners, top corners removed on nuetral, vent holes at top. Also i will blast my plates but should i do this after or before i give them to the shop? Do you recommend blasting both sides? btw im sure when i read my post later i will see all the info i left out lol:p

[BioFarmer93]

Hey Byrd,
No problem.. Find out if the shop likes .dgn, .dwg or .dxf.. I don't charge. You blast after they're cut out. You want a 15 plate 2 stack reactor that's fed and vented from both sides with a no-hole center pos plate. I'll draw it up at lunch tomorrow if there are no calamities in the morning, probably take a good 30 min.:D

[byrd9790]

your the man ~bows~ :D

[byrd9790]

dgn is what he told me but he also told me that they have most software to convert.