NorCalWheeler
03-26-2012, 02:44 PM
Hi,
I have installed a MAF enhancer on my vehicle 96 tacoma. Would I benefit from installing a Narrow Band efie also? With the MAFe installed i can turn the fuel down untill the engine stalls, so it is obviously leaning the engine out. When driving and switching between factory and enhanced i can watch the fuel monitor on the scan guage and see that it is using less gas. I am basicly trying to make to most gas(hho) possible with my system. I am novice on this thing, i dont know a whole lot about fuel systems and electronics but am trying to save some money in gas (obviously)
I have a 16 plate cell with 316L stainless +nnn-nnn+nnn-nnn ( this is how the instructions that came with the cell said to hook it up) ,scan gauge 2, 70amp pwm, MAF enhancer, and i also got a 130amp High output alternator that i havnt installed yet.
The instructions that came with the cell also say to run 2 tablespoons of lye per gallon of distilled water. Ive been running the pwm at 500hz and 90% duty cycle. The cell gets warm but not hot. Can i run more electrolyte to produce more gas? No browning of water. I dont actually know how many amps i am pulling but i figured not that much because its not getting that much extra current from the stock 80 or 90 amp alternator, so im sure that will change when i put that on in the next day or so.
I would love to hear any suggestions from you all....thanks!!
I have installed a MAF enhancer on my vehicle 96 tacoma. Would I benefit from installing a Narrow Band efie also? With the MAFe installed i can turn the fuel down untill the engine stalls, so it is obviously leaning the engine out. When driving and switching between factory and enhanced i can watch the fuel monitor on the scan guage and see that it is using less gas. I am basicly trying to make to most gas(hho) possible with my system. I am novice on this thing, i dont know a whole lot about fuel systems and electronics but am trying to save some money in gas (obviously)
I have a 16 plate cell with 316L stainless +nnn-nnn+nnn-nnn ( this is how the instructions that came with the cell said to hook it up) ,scan gauge 2, 70amp pwm, MAF enhancer, and i also got a 130amp High output alternator that i havnt installed yet.
The instructions that came with the cell also say to run 2 tablespoons of lye per gallon of distilled water. Ive been running the pwm at 500hz and 90% duty cycle. The cell gets warm but not hot. Can i run more electrolyte to produce more gas? No browning of water. I dont actually know how many amps i am pulling but i figured not that much because its not getting that much extra current from the stock 80 or 90 amp alternator, so im sure that will change when i put that on in the next day or so.
I would love to hear any suggestions from you all....thanks!!