Questions?

[mikeinri]

Hello,

Are anyone's generators operating under pressure?

Production will drop off but could I get an example if anyone is producing at say 5psi discharge?

I looked on line and the higher output HHO are priced at over $1000.

Does anyone have one that is turning out over 8 lpm?

Has anyone tried running them in a negative pressure?

Has anyone tried a thermistor to vibrate the water to raise production?

Has anyone been using a mini air pump to create pressure at a torch tip?

Thank you

[myoldyourgold]

Are anyone's generators operating under pressure?

I have tested from 2 psi to 12 psi. I am running between 4 and 5 psi which is where I get the best performance with my reactors. Pressure helps keep the bubbles small which contributes to less bubble occlusion.

Production will drop off but could I get an example if anyone is producing at say 5psi discharge?

Production does not go down at 5 psi necessarily but varies with the design of the reactor. The pressure is caused by resistance out side of the reactor.

I looked on line and the higher output HHO are priced at over $1000.

Does anyone have one that is turning out over 8 lpm?

For larger volumes of gas it is more efficient to run multiple reactors in parallel to get what ever volume you need. The larger reactors are not as efficient and suffer with flow/heat problems. I have one reactor that can run at 8 LPM but it is much more efficient at 6 LPM which is what it is designed for.

Has anyone tried running them in a negative pressure?

Some have but I have not.

Has anyone tried a thermistor to vibrate the water to raise production?

Testing is on going but there are easier methods of getting more energy to brake the bonds.

Has anyone been using a mini air pump to create pressure at a torch tip?

I have not and do not know of anyone how has.