madman
01-14-2012, 09:16 PM
I have lots of details and ideas for the cell but for right now lets just look at the basics (mostly size)
2.5 LPM at estimated 13 amps per litre of gas. this is32.5 amps. At 13.8 volts thats 448 watts. At 2500ml. of gas that is aMMW of 5.5. At .5 amps per sq. inch active area that means my plates need to be 6.5x10 not counting gasket, tabs,entry hole, gas exit space at the top.
For now please figure the build will be done with all the correct materials and procedures like 316l,media blast,weldon,edpm, hdpe,koh, pasivation,staggered entry holes, dual charged tabs,placement of ports , etc.
This will be for a blazer with a 4.3 littre engine. Configuratioin is 8 plates/6 bipolar 7cells. Will this set up work and if not please explain . If not then what would be best?
Thanks in advance
Mark
2.5 LPM at estimated 13 amps per litre of gas. this is32.5 amps. At 13.8 volts thats 448 watts. At 2500ml. of gas that is aMMW of 5.5. At .5 amps per sq. inch active area that means my plates need to be 6.5x10 not counting gasket, tabs,entry hole, gas exit space at the top.
For now please figure the build will be done with all the correct materials and procedures like 316l,media blast,weldon,edpm, hdpe,koh, pasivation,staggered entry holes, dual charged tabs,placement of ports , etc.
This will be for a blazer with a 4.3 littre engine. Configuratioin is 8 plates/6 bipolar 7cells. Will this set up work and if not please explain . If not then what would be best?
Thanks in advance
Mark