madman
12-10-2011, 10:00 AM
The design I am building calls for 4 slots in the plates which line up with the dividers and end plates. Due to low budget I cut my plates including notches for electric conn. myself. If I drill holes (same area aprox. 1/4 inch) will this be a problem? Or should I drill several holes slightly larger side by side with a small gap inbetween them to equal the required area?
Plates cut,gaskets cut, dividers cut,drilled, taped, bublers made. Waiting for the brown truck to deliver fittings, hose,resivoir, difusers, check valve and koh.
P.S. Next build will be with water jet cut plates. Please reply with who you use for this.
Thank You, Mark
Plates cut,gaskets cut, dividers cut,drilled, taped, bublers made. Waiting for the brown truck to deliver fittings, hose,resivoir, difusers, check valve and koh.
P.S. Next build will be with water jet cut plates. Please reply with who you use for this.
Thank You, Mark