madman
11-16-2011, 09:33 PM
Build will be 7 groups with 7 plates each with 6 dividers and 2 end plates made of 1 inch hdpe. Plate size is 5 inch wide and 3.5 tall. Plates will have 2 slots at top for gas out and 2 slots at bottom for elite in.
This is how I think it is plumbed. Dividers have 4 holes drilled all the way thru where they connect with the slots in plates thus 2 left for elite in and 2 right . Same for gas out 2 left and 2 right. Now to connect these holes more holes must be drilled in the edges (top and bottom) to meet these holes in the faces. Half the amount ,4 meaning 2 ontop for gas out and 2 on bottom for elite in.Even though there is only 4 holes thru the face there is actually 8 holes if you count both sides.
Is this correct, if not please explain. The question is, how are all the hoses connected together to go to resivoir and bubblers?Planning on using 3/8 npt fittings with 3/8 barbs.
This is how I think it is plumbed. Dividers have 4 holes drilled all the way thru where they connect with the slots in plates thus 2 left for elite in and 2 right . Same for gas out 2 left and 2 right. Now to connect these holes more holes must be drilled in the edges (top and bottom) to meet these holes in the faces. Half the amount ,4 meaning 2 ontop for gas out and 2 on bottom for elite in.Even though there is only 4 holes thru the face there is actually 8 holes if you count both sides.
Is this correct, if not please explain. The question is, how are all the hoses connected together to go to resivoir and bubblers?Planning on using 3/8 npt fittings with 3/8 barbs.