dry cell cost

[linkintiger]

what was your material cost and for what size of a dry cell when you guys where building one (just the cell material )?

mine was

$58 for 16 6x6 ss plates LOCAL SHOP
$19 rubber gasket material 1/8 inch tick ACE hardware
$20 barb fitting,cutting boards and screws and 1/2 inch hose MENARD
so almost a $100

[cabrera]

what was your material cost and for what size of a dry cell when you guys where building one (just the cell material )?

mine was

$58 for 16 6x6 ss plates LOCAL SHOP
$19 rubber gasket material 1/8 inch tick ACE hardware
$20 barb fitting,cutting boards and screws and 1/2 inch hose MENARD
so almost a $100
About the same but I used
1/2 " high temperature Cast Acrylic end plates and
the zinc plated nuts, bolts, & washers
Unfortunately, the acrylic sheet was bigger than I needed so it cost more overall.
But I will be building more cells