DRY CELL electrode spacing

[Jordan_Bailey84]

I was wondering if anyone has info on dry cell electrode spacing. Im stuck between 1/16 and 1/8 I may go middle of the road and go with 3/32. if you have experience in this area please share your results in relation to heat, HHO production, amps, and foam produced. Thanks

[Owen_]

I haven't done much experimenting myself, but from what i've heard 3mm which is about 1/8" is ideal. It seems to me that you could go smaller if you have a pump and a cell designed for a pump. (which is what i'm planning)

[b1jetmech]

For my 10"x10" trucker cell plates I went with .200 in spacing. With plates that large, it needed enough space for the gas to escape. Besides, that spacing I'm using could be widen for higher outputs. .125 might be too tight for plates this big.

Chase