gwidijanto
07-24-2009, 05:21 AM
Hi all,
I have problem calculating the right lpm for my next cell, since so many formulas that makes me confuse.
I'm gonna make a new dry cell with isolated connection holes between each plate too prevent current leakage.
The configuration is like this:
|[+-]|[+-]|[+-]|[+-]|[+-]|[+-]|
[ & ] = stainless steel plate
| = isolator plate, ie:acrylic plate
it is like 6 individual cell connected in series.
With 10 Ampere at 13,8 volt, how much lpm of HHO can be produced with this configuration?
How big the ss plate should I make?
Please show me the right calculation for this setup.
BTW, for car with 1600cc engine, gasoline fuel, how much HHO (lpm) should I produce to gain 35-40% saving in fuel. (just raw estimate).
Thankyou in advance for your help.
gw.
I have problem calculating the right lpm for my next cell, since so many formulas that makes me confuse.
I'm gonna make a new dry cell with isolated connection holes between each plate too prevent current leakage.
The configuration is like this:
|[+-]|[+-]|[+-]|[+-]|[+-]|[+-]|
[ & ] = stainless steel plate
| = isolator plate, ie:acrylic plate
it is like 6 individual cell connected in series.
With 10 Ampere at 13,8 volt, how much lpm of HHO can be produced with this configuration?
How big the ss plate should I make?
Please show me the right calculation for this setup.
BTW, for car with 1600cc engine, gasoline fuel, how much HHO (lpm) should I produce to gain 35-40% saving in fuel. (just raw estimate).
Thankyou in advance for your help.
gw.