velorossa22
03-14-2009, 08:13 PM
This may be a dumb question, but I'm just learning about electronics. I got zero's dual efie (with all the electronics on it) and I'm wondering what people use to terminate on the PCB where there's the ground, 12V, O2-1, etc. My board just has these holes in it and I'm not sure what you use to finish. Also what are people using for a mounting box for the board? Does mouser or anyone like that have a project box that small? Just wondering what you guys are doing to finish. Also do you guys have to take the thing apart every time you want to change the output to the O2 sensor?
I will say the efie is very nice. Solder joints and everything look very solid. What kind of fuse are you using for it? Are you just tying into the ignition circuit for the whole system or are you running it on it's own circuit?
Sorry about all the questions.
Thanks you guys!:D
I will say the efie is very nice. Solder joints and everything look very solid. What kind of fuse are you using for it? Are you just tying into the ignition circuit for the whole system or are you running it on it's own circuit?
Sorry about all the questions.
Thanks you guys!:D