BoyntonStu
03-13-2009, 07:01 PM
A few notes:
I had to assemble/reassemble a few times due to my error and to reposition a leaking gasket.
The plates are perfect and every screw fits its aligned hole.
Thank you SCM!! Your plates are the best!
My first build had 7 and 5 instead of 6 and 6 “E” plates.
Next, under 25 PSI one gasket was too loose and it blew out sideways.
It went together for the 3rd time and only leaked a tiny bit. Submersed in a bucket of water.
A few tightened screws and it stopped leaking.
No electrical problems with the 1/32” Neoprene gaskets.
I ran it for about 5 minutes with 11 Amps @ 14 Volts.
So far, it appears to be running OK.
More to come.
BoyntonStu
http://i348.photobucket.com/albums/q339/BoyntonStu/AmoebaCellwithfeet3-13-09002.jpg
I had to assemble/reassemble a few times due to my error and to reposition a leaking gasket.
The plates are perfect and every screw fits its aligned hole.
Thank you SCM!! Your plates are the best!
My first build had 7 and 5 instead of 6 and 6 “E” plates.
Next, under 25 PSI one gasket was too loose and it blew out sideways.
It went together for the 3rd time and only leaked a tiny bit. Submersed in a bucket of water.
A few tightened screws and it stopped leaking.
No electrical problems with the 1/32” Neoprene gaskets.
I ran it for about 5 minutes with 11 Amps @ 14 Volts.
So far, it appears to be running OK.
More to come.
BoyntonStu
http://i348.photobucket.com/albums/q339/BoyntonStu/AmoebaCellwithfeet3-13-09002.jpg