mobman1
01-07-2009, 03:02 PM
Ok guys i basically tested all the 3 wires that come out of my MAF module and they are as follows:
RED wire = Constant voltage of 12.8 volts...increases slighty when accelerated.
Black/white wire = multimeter shows changing volts in the .786 range and will increase if accelerated but is constantly changing
black/green wire = non constant voltage in the 108.45 range...will decrease if accelerated.
Which one of the above wires do you think needs to be tapped for the MAF/MAP enhancer module?
RED wire = Constant voltage of 12.8 volts...increases slighty when accelerated.
Black/white wire = multimeter shows changing volts in the .786 range and will increase if accelerated but is constantly changing
black/green wire = non constant voltage in the 108.45 range...will decrease if accelerated.
Which one of the above wires do you think needs to be tapped for the MAF/MAP enhancer module?