Smyler86
10-17-2008, 12:54 PM
Hello
Well, after being glued to Painlesses thread I finally got my act together and built a dry cell, Its 316 SS 7 plates 125mm x 100mm with rubber gaskets 3mm spacing. With 2 5mm Acrilic plates to hold it all togeter (I know these are thin, i'm going to buy some 10mm)
I got some Koh from Ebay but i think its not very good, put about 300g in 1L of water and this is what I got:
Volts: 12.2
Amps: 5.4
ML: 500
Secs: 98
MMW: 4.65
Just a few Q's:
1. I used De-Ionised water, is that ok? (Battery top up water)
2. When I add more Koh it "fizzes" for a few seconds and gets warm, is that normal?
3. Is hydrogen slightly cloudy??
Thanks for your help!
Dan
Well, after being glued to Painlesses thread I finally got my act together and built a dry cell, Its 316 SS 7 plates 125mm x 100mm with rubber gaskets 3mm spacing. With 2 5mm Acrilic plates to hold it all togeter (I know these are thin, i'm going to buy some 10mm)
I got some Koh from Ebay but i think its not very good, put about 300g in 1L of water and this is what I got:
Volts: 12.2
Amps: 5.4
ML: 500
Secs: 98
MMW: 4.65
Just a few Q's:
1. I used De-Ionised water, is that ok? (Battery top up water)
2. When I add more Koh it "fizzes" for a few seconds and gets warm, is that normal?
3. Is hydrogen slightly cloudy??
Thanks for your help!
Dan