richardb200373
09-17-2008, 06:44 PM
Need some opinions on cutting, sanding and grinding edges of the plates.
Also, I saw a website that talked about a 3 phase demagnetizing of plates.
I read some of the earlier forums about cutting with a dremmel or pnuematic cut off tool, sounds good, what about using a chop saw on stainless? Should there be any concerns of using high speed electrical equipment, will there be a magnetizing change? Next, sanding, what does everyone think about sanding the plates on a belt sander, maybe 80 grade.
And last, any input on grinding the edges a little to get rid of any sharp edges. Oh, one more, anyone know about demagnetizing? Thanks again.
Also, I saw a website that talked about a 3 phase demagnetizing of plates.
I read some of the earlier forums about cutting with a dremmel or pnuematic cut off tool, sounds good, what about using a chop saw on stainless? Should there be any concerns of using high speed electrical equipment, will there be a magnetizing change? Next, sanding, what does everyone think about sanding the plates on a belt sander, maybe 80 grade.
And last, any input on grinding the edges a little to get rid of any sharp edges. Oh, one more, anyone know about demagnetizing? Thanks again.